TSP-BFM24

The TSP-BFM24 buffer module will hold the output voltage of a 24 VDC power supply after brown outs or voltage dips of ten 50 Hz cycles at full load. During this buffer period no deterioration of the 24 VDC output voltage will occur. For many applications this buffer module is an ideal and cost effective alternative to a battery based backup system. The buffer module consists of a large bank of capacitors. When the power supply is switched on, the buffer capacitors will be charged. This will take approximately 30 seconds and an opto-coupler signal indicates the “READY“ condition. When a power fail occurs, the capacitor bank is discharged, maintaining the output of the buffer module at its nominal voltage. This condition is indicated by a “POWER FAIL“ signal. The hold up time is typically 200 ms at 25 A and 4 seconds typically at 1.2 A. After 4 seconds the buffer device will switch off the output voltage. The operating modes of the module are also indicated by a LED on the front panel. The major advantage of this buffer solution is, that it is fully maintenance free and its storage capability does not deteriorate over the live time of the product.

Монтаж
Монтаж	Клеммная колодка
Рабочая температура
Рабочая температура	-25°C~+70°C
Основные
Вес	745 г.
Выходное напряжение	24 В
Выходной ток	25 А
Дистанционное вкл./выкл.	Нету
Количество выходов	1
Конструкция	Металлический корпус
Мощность	600 Вт
Напряжение питания	24...28 В
Длина	110 мм.
Ширина	54 мм.
Высота	110 мм.